Triumph Rat Motorcycle Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2,352 Posts
Discussion Starter #1
Just done. Tightest inlet @ 0.76 (number 1 cylinder outboard valve) ditto exhaust 0.15 (same cylinder, outboard). Will check both at another 8,000 miles.
All other exhaust valves at 0.17-18 so very good engineering Mr Triumph after 24,000 miles total.
Top engine cover removed/replaced (with gr8t care) no problems with gasket seating correctly. There is a definite knack to this, incorporating I am sure, a measure of good luck!
 
1 - 1 of 1 Posts
Top