You will need two different torque wrenches, 1/4” drive and 3/8” drive. Precision Instruments are built for Snap On if I heard right. They are much more economical than SO. Depending on your budget.
Torque wrench suggestions for Tiger 800
I'm going to start doing some basic maintenance like oil change, coolant changes and chain tightening on my 2016 xrt. I've never used or owned a NM torque wrench.
Looking for suggestions.
I see the needs of tiger torquing are as low as 1.5 NM for coolant tank nuts and up to 120 for rear axle chain tightening.
I assume I don't need top of the line but I read on Amazon that some poorer brands break easily.
Sent from my SM-G960U using Tapatalk
Looking for suggestions.
I see the needs of tiger torquing are as low as 1.5 NM for coolant tank nuts and up to 120 for rear axle chain tightening.
I assume I don't need top of the line but I read on Amazon that some poorer brands break easily.
Sent from my SM-G960U using Tapatalk
1 - 1 of 2 Posts
1 - 1 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Triumph Rat Motorcycle Forums
A forum community dedicated to Triumph Motorcycle owners and enthusiasts. Come join the discussion about performance, racing, cafe racers, bobbers, riding, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
rambo
175 Replies
FLY-TRI-GUY
167 Replies
StuartMac
145 Replies
Recommended Communities
