Triumph Rat Motorcycle Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
When I move the engine in the direction of rotation for starting, the pin that slides through the threaded fitting plug behind the cylinders, it goes by the 37 degree btdc position and only falls in place at tdc. Anybody know what is going on here?
 

·
Registered
Joined
·
77 Posts
I just went through this. The 67 only has the hole at TDC. There isn't one at the fully advanced position. You need a degree wheel to find it.

Steve
 
1 - 2 of 2 Posts
Top