Triumph Rat Motorcycle Forums banner

removing headers...

4993 Views 16 Replies 9 Participants Last post by  Perkology
Whats the easiest way to remove the headers? I was checking it out and it looks like i have to remove a few parts before I can unbolt the right side header...anybody got a secret to doing this more easily? Thanks!

Also, as far as removing the blue, Blue Job works great, but it doesnt seem to have any effect on the yellow/gold. Whats the best way to go about removing the gold...Buffing wheel???

[ This message was edited by: GrayMitchell on 2007-01-30 21:48 ]
1 - 2 of 17 Posts
1st step PB BLASTER OR LIQUID WRENCH LET IT SIT FOR 1 DAY. Alway let it soak for 1 day. Breaks things up less likely to snap something. Then once you remove it drive it down to you local podwer coat plating shop. Let them fix it so it never comes back.

[ This message was edited by: evand on 2007-02-01 01:50 ]
powder coat is pretty tough I have used powder on exhaust for a gsxr and ran over 20k miles without problems, I just had it done to my project gs check the pics i posted in the general section
1 - 2 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top