Triumph Rat Motorcycle Forums banner
  • Hey everyone! Enter your ride HERE to be a part of September's Bike of the Month Challenge!
1 - 15 of 15 Posts

·
Registered
Joined
·
492 Posts
Discussion Starter · #1 ·
anyone have the diameter of the rear pin for the 1050 ?

i know there are different sizes for eacn side , any got a micrometer or vernier to measure their bulldog or triumph pins ?
 

·
Registered
Joined
·
2,971 Posts
On 2006-12-17 21:37, KungFooJimmy wrote:
Measuring mine, I get 27 mm.

Oh man, I'd hate to have that sentence misinterpreted. :-D
Pencil dick :-D
 

·
Registered
Joh Bloor Special
Joined
·
1,408 Posts
Is that length or width Jimmy? :-D
 

·
Registered
Joined
·
973 Posts
It's not very wide but at least it's short :-D

Thats great limey. LOL. I had a buddy we used to call stumpdick. :-D Figure it out.

[ This message was edited by: itchin on 2006-12-17 23:07 ]
 

·
Registered
Joined
·
492 Posts
Discussion Starter · #10 ·
seven replies and one useful one , i think thats close to a record for

helpful.


27 mm thanks
 

·
Registered
Joined
·
112 Posts
Mine's short but it's as big around as a tuna can. :wink:
 
1 - 15 of 15 Posts
Top