Triumph Rat Motorcycle Forums banner
1 - 1 of 1 Posts

64 Posts
Discussion Starter · #1 ·
Just in case you guys are looking to get rid of the rear peg.

I lost one of my peg yesterday. I may not tightened the peg enough while replacing the exhaust.

I've searched but did not find any posting regarding the bolt size for it.
I saw that newBonneville has a kit but I am not willing to wait because I do not want my exhaust to fall off while riding it to work.

So I went to Lowe's today and got the following

Stainless Hex Cap Screws size 5/16-18 x 1-1/2
Stainless Hex Nuts 5/16-18
Stainless Fender Washers 5/16 x 1-1/2

I hope this helps.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.