Triumph Rat Motorcycle Forums banner
  • Hey everyone! Enter your ride HERE to be a part of October's Bike of the Month Challenge!
1 - 1 of 1 Posts

373 Posts
Discussion Starter · #1 ·
I've finally taken the plunge to purchase an Arrow 3-in-1 for my 2008. :D

I've seen a picture on this forum of a guy who put sliders where the highmount exhaust used to be. Does anybody know what slider was used for this? If you check out this picture, you can see where the slider would be mounted.

The original passenger footpegs act as really good protection for the rear. Now that I'm thinking about going with the Daytona 675 ones, I don't know if it'll offer the same protection for the exhaust even with that additional slider.

What have you guys done to protect your $1000+ Arrow exhaust?
1 - 1 of 1 Posts