Triumph Rat Motorcycle Forums banner

oil,temp, hi beam bulb removal

854 Views 5 Replies 4 Participants Last post by  Johnjohn
G
Hey guys I've read all the threads, I've got the tach speedo pods apart for bulb replacement on '98 TBS
for the tiny, idiot light bulbs in between the tach/speedo but can't figure out how to get the little %*#^ 's out..... Haynes Manual on order....would that really help? I've twisted and pulled the small rubber rings holding the wires with a pin nose plier.............but nada, any help appreciated, sorry for the lame request....the fly screen doesn't help either. I just removed ,cleaned, jets, carbs, airbox; geez.... I thought I could replace a couple of miniature bulbs.... for the lov a .............

[ This message was edited by: thaw on 2007-01-30 17:06 ]
1 - 1 of 6 Posts
Hmmm... that's wierd both my bikes they come out the back. the black rubber holders just snap into the dash panel, and the bulbs are very easy to reach that way. I put some vaseline on them when I put them back together so they will be easier to remove next time.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top