[Guest]

Hey guys I've read all the threads, I've got the tach speedo pods apart for bulb replacement on '98 TBS
for the tiny, idiot light bulbs in between the tach/speedo but can't figure out how to get the little %*#^ 's out..... Haynes Manual on order....would that really help? I've twisted and pulled the small rubber rings holding the wires with a pin nose plier.............but nada, any help appreciated, sorry for the lame request....the fly screen doesn't help either. I just removed ,cleaned, jets, carbs, airbox; geez.... I thought I could replace a couple of miniature bulbs.... for the lov a .............

[ This message was edited by: thaw on 2007-01-30 17:06 ]

 

[TexasTri]

For what it is worth Haynes manual says to 'gently pull the bulbs out of their holders' then it has a picture of a guy holding the bulb from the holder, so I guess just pull it out.

 

[Guest]

I've been pulling from the back/wireside toward the headlight....... corrct? Thanx Russ....jeff

 

[Wombat]

They come out from the front.

 

[denny]

Hmmm... that's wierd both my bikes they come out the back. the black rubber holders just snap into the dash panel, and the bulbs are very easy to reach that way. I put some vaseline on them when I put them back together so they will be easier to remove next time.

 

[Johnjohn]

Just pull the rubber socket gently out back (wire side) use som WD40 og try to heat it a little (hairdryer or so)
Then replace the bulp. No magic ....

JOhn