Triumph Rat Motorcycle Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
I recently replaced the Oil Pressure Switch on my D650. Since it hasn't been run since it's replacement (I replaced it right after my electrical system failed) I don't know if it works.

Is the installation really as easy as it seemed? Unscrew connecting wire, remove old, install new and hook the wire back up. If so, that's the easiest DIY project ever.
 

·
Registered
Joined
·
16 Posts
Discussion Starter · #4 ·
That is the same thing I was thinking. I do believe, however, that these type of connectinos are convex around the inside of the connection so that oil comes out of the small holes and can flow around the bolt and into the tube no matter which way the holes are pointing.

Did you have success in lining up your mark? I was going to attempt that, but figured the odds were pretty slim. :)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top