Hello - Anyone out there happen to know what the recommended torque setting should be for the crankpin nuts on a 1934-36 L2/1 250? Very similar to T70 single engine so I presume that if someone knows that figure then this may help. Building this bike for historic racing so any info or parts also appreciated. Thanks Sputnik
L2/1 250 Single - Flywheel Torque Setting
Join the discussion
Recommended Reading
-
Clogged main jet?? (Video)
Maintenance & Workshop TalkBought an ‘07 speed master cheap that I’m trying to get running. I’ve gone through the carbs twice now but am a first-time mechanic so maybe I did a poor job. the bike has a nice idle. It rides around the block as long as I keep it under maybe 2000 RPMs or so, before it cuts out like it’s...- 0
- 46
-
2006 Speed Triple - Issue starting when warm to hot
Maintenance & Workshop Talk2006 Speed Triple 17.5K miles The bike starts fine when cold or just a little warm. At these temps I can start, turn off the bike and then try again and it will start. It also starts up when hot but but takes a bit more effort maybe 2-4 cranks more than if it were cold. The biggest issue is...- 2
- 241
-
No Power To Dash Or Dials
Maintenance & Workshop TalkHi everyone and thanks for help in advance, I have a 2008 triumph sprint st 1050, which was working fine when I put it away for the winter. Now she's back out again I can't get any life out of her. The headlights are working and there's clicking sounds coming from inside the bike when I turn...- 2
- 130
-
Derekthedino · updated
-
yet another wheel cleaning thread
Maintenance & Workshop TalkYep, wheel cleaning. Especially the rear wheel that gets a lot of abuse from chain lube. I used to use WD40 to clean my Suzuki TU250X chrome wheels, but now that I've got a Street Cup, I'm not sure if the same will be suitable for the wheels since they're cast from.....not the same stuff...- 1
- 104
-
Halo on LED Headlights not working
Maintenance & Workshop TalkHello! I recently installed one of those cheap eBay led lights on my 14’ Bonneville. The light is working fine but I can’t get the halo ring to turn on at all The light has a H4 connector and there is another connector that v’s from that same line, which I assume is the connector that lights up...- 0
- 53
Join now to ask and comment!