Triumph Rat Motorcycle Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Bike of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 · (Edited)
Can someone tell me what size of hex socket driver I need to remove the hex 'screw' that holds the ignition sensor in place ? The screw in question is listed on bikebandit.com as

SCREW,SHLD,SKT,M6X1.0X15,S/S M6 X 12MM PN 5576239-001

and is for a 1996 Adventurer (lower serial number)

I can't seem to get a good solid hold of it with anything in the 6, 7, or 8mm hex socket range, and its starting to round off.
 
1 - 2 of 2 Posts
Top