Triumph Rat Motorcycle Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
Hi folks-

I'm missing my bezel that surrounds my ignition- what keeps it tight in the top tree. In other words, its just hanging there, loose and flopping around, and lower than if it was mounted and supported.

I went to a dealer- in Daytona, and the parts manager can't find it, we looked on the charts for ignition, forks, body, fuel tank, everything.

Any ideas about a part #? Thanks...
 

·
Registered
Joined
·
50 Posts
Discussion Starter · #4 ·
Shear bolt was gone-

The ignition was held flush with a bezel, and tie wrapped to hold it from falling out- tie broke- if you look at your bike, you'll the trim around the ignition- doesn't show up on the schematic...
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top