Could you MacGyver some taller wheels on the stand in place of the standard ones? Perhaps some that are intended as replacements for a cheap lawn mower?
Front End Lift For Rally Pro
I was wondering what folks have used for a front end lift for the Rally Pro.
I have both front and rear Vortex Paddock stands. Rear works fine. But the front, with the the 21” wheel and 230mm of travel, the front stand isn’t tall enough to fit the pin. Trying to avoid building a set of lift blocks (2X8’s and 2X4’s etc…) but if that’s the only way, I will go that route. I have an “A” frame that I can hang the front from, but it takes up too much room.
Any thoughts or suggestions?
Cheers,
RD
I have both front and rear Vortex Paddock stands. Rear works fine. But the front, with the the 21” wheel and 230mm of travel, the front stand isn’t tall enough to fit the pin. Trying to avoid building a set of lift blocks (2X8’s and 2X4’s etc…) but if that’s the only way, I will go that route. I have an “A” frame that I can hang the front from, but it takes up too much room.
Any thoughts or suggestions?
Cheers,
RD
1 - 2 of 7 Posts
I was referring to installing taller wheels on the paddock stands
I use both methods. The floor jack works fine for something quick but the paddock stand provides better stability for longer jobs.
I use both methods. The floor jack works fine for something quick but the paddock stand provides better stability for longer jobs.
1 - 2 of 7 Posts
Triumph Rat Motorcycle Forums
A forum community dedicated to Triumph Motorcycle owners and enthusiasts. Come join the discussion about performance, racing, cafe racers, bobbers, riding, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
rambo
175 Replies
FLY-TRI-GUY
169 Replies
StuartMac
149 Replies
Recommended Communities
