Triumph Rat Motorcycle Forums banner

brembo / pazzo lever install:

997 Views 7 Replies 5 Participants Last post by  moyster
hey guys,

has anyone fittted a pazzo lever to their brembo MC?

the ONLY thing i can see that's keeping me in the way of getting the lever off is this tiny little sleeve that's in the knob of the adjustment screw on the MC.

am i to take that small sleeve out, or do something else? (before i wreck that sleeve taking it out)

thanks in advance,

note: the adjustment for the lever travel obviously doesn't come out. so it leaves me to think that tiny sleeve is the only thing keeping that knob on.

[ This message was edited by: zooplancton on 2007-02-11 16:10 ]
See less See more
1 - 2 of 8 Posts
that's a roll pin, use a small punch to push it out. It will take some effort, a small hammer may help.
If you plan on re-using the pin, you "should" get a replacement. They're designed for a one time use, but could realisticly be used a couple of times.
1 - 2 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.