Triumph Rat Motorcycle Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Bike of the Month Challenge!

1 - 6 of 6 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I'm looking to lower and mvoe further forward my pegs
Is it a relatively easy job to fit Bonneville pegs on a Thruxton ?

Has anyone done it?

what parts are needed and ow much would it cost ?
 

·
Registered
Joined
·
93 Posts
I have not done it but i was looking into going bonnie to thrux mounts before i got my LSL rear sets.

I think all you would need is the cast swing arm pivot brackets that the pegs bolt to, the pegs, any linkages attached to them and the rear master cylinder.
 
1 - 6 of 6 Posts
Top