Triumph Rat Motorcycle Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
I recently put a new on/off switch on my bike because the old one was damaged in a crash, flushed coolant, installed new tail light, and changed oil in my 2007 S3. I test rode it, ran fine. after putting my rear fairing back on and cleaning the garage I decided to go for a ride. NOTHING. Bike would not turn over at all. My check engine light came on for about ten seconds while I had it running, but went right off. I tested a few things.
Battery is pumping around 12 v
But there is no power going to cylinoid. Does any body have any advice???? It ran fine when I tested it out. I am so lost/bummed out right now.
Thank you
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #3 ·
Thank you. GEEEE I could really use a wiring diagram. I am just so bummed out about this whole thing. I rode it fine. ten minutes later it is playing head games.
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #6 ·
I used a tester. Couldn't find anything. So my brother in law and I decided to go peice by peice. It ended up being clutch safety switch. Now I am back riding. Except... I need my fork seals redone.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top