Search Results for ‘scrambler’

Hi all. Just picked up new 2022 Street Scrambler yesterday. Man is it fun to ride. Any suggestions for luggage rack. The TEC one doesn’t look like it will fit the 2022 the way it’s designed near brackets with bolts. Or suggestions for bag/pannier that’s sleek and not too large.

Hello, I have a 2016 scrambler with 3k miles on it. I've noticed the motor making a ticking noise while idling after warming up... just trying to figure out what the potential causes might be? It also has a hard time idling sometimes and will die. air intake has already been deleted...

Hello all! I have a 2009 Triumph Scrambler EFI w/cable speedo. So recently I got the itch to completely gut the bike and remove any unnecessary wiring, parts, sensors ETC. My enthusiasm seems to have bit me back as my bike will not start. -When pressing my "start" switch, nothing happens...

Hi there, awaiting the arrival of my new project bike, freshly imported from US, and need your help! Front forks require attention and I’m thinking of a proper upgrade this time. It will be used only off-road, certainly knobblies on the rear and probably front too. I’m looking to keep it in...

I know some people on here have vouched for the quality of KiWAV's mirror, but I'm wondering if anyone has tried the Eclipse model specifically. They look like a nice alternative to stock. I'm looking for something to replace the bar-end CRGs on my Scrambler...

Title says it all, had a relatively minor 30 mph laydown a few months ago. Tore my acl and meniscus and now that those are finally healed it's time to fix up the bike. Some of this happened off road (hence the tape and dirt) and the rest on the ride home. Here is a list of stuff I know is...

Good evening fellow riders. I'm kinda sad that my first post in this forum has to be because of a technical problem in my precious Street Scrambler... But this is how it is. I own a street scrambler 2018 water-cooled, Mods: Camshaft (de restrict) Street Scrambler 900cc from tecbikeparts, DNA...

Newbie here. Handy, but not really familiar with engines and definitely not these engines. Went to go for a ride yesterday (last ride was 2 weeks ago)...2006 Scrambler. A bit tough to start and was dying as soon as I would add throttle. Tried heading down the block, had super low power. Parked...

Hey All, new to page. I have just bought a 2011 Scrambler 900 and was looking for some solutions for a backrest w or w/o luggage rack. I don't want to take a pillion without backrest, so was wondering what options there were out there. I was hoping that the Bonneville ones might work, but...

I was wondering if someone could help shed some light on a query. Do all bonnevilles with LED headlights, use the same dimension headlights? I have a 2020 scrambler 1200xc and the headlight is awful\dangerous, so looking to replace it but the third Party ones I have been looking at don’t seem...

Guys, my 2016 triumph scrambler engine failed on me at 50k due to a bad oil pump gear. Now I’m looking at doing an engine swap. I know that the Bonnie/ thruxton engines will not work without some wire harness and coil work but since the speed master is a 270 will it work? I’ve done a little...

Bought a scrambler which has an arrow 2-1 exhaust. The bike runs smooth and with no backfire but Maybe a little lean... Want to check the map configuration on the bike. Not quite sure where to start. Do have interface between the obd and computer. What software to use, where to get ECU tune?

Hi, What kind of oil is reccomended? My plan is to use Castrol 10w40 fully synthetic.

Hi everyone the new street scrambler now has a 4pot Brambo calliper to address the braking on older models. I was looking at upgrading the brakes on my 2017 model but the free spirit kits are expensive :eek: I have seen a 2019 Brembo calliper for sale on an auction website do you know if it will...

hey fellow T-rats (well not officially a T-rat yet...) I am looking to buy a 1200 XE (do I need to explain why?) and, well, I am a fairly short rider (5'8" - 174cm with 31.5" rider inseam) - so looking at ways to lower the bike somewhat. Don't need my 2 feet flat on the floor, but flatter is...