Triumph Rat Motorcycle Forums banner

led

  1. Water Cooled Twins Technical Talk
    I'm considering buying aftermarket LED rear and front indicators. Wondering if anyone has fitted any to replace the OEM ones? If so, did you need to install a relay to get the proper flashing rate?
  2. Air Cooled Twins Technical Talk
    I was wondering if someone could help shed some light on a query. Do all bonnevilles with LED headlights, use the same dimension headlights? I have a 2020 scrambler 1200xc and the headlight is awful\dangerous, so looking to replace it but the third Party ones I have been looking at don’t seem...
  3. Street Triple 765
    OEM or aftermarket is fine. I'm having a hell of a time figuring out what's going on. My right side LED signals work and my left don't. I've swapped around all 4. All of them have the same resistance. Left side front and back are having the same issue. Right now my bike has the right side LEDs...
  4. Street Triple 765
    The only "permanent" modification to the bike was cutting the license plate light wire to reuse the connector. The fender eliminator didn't fit perfectly at first and took a blow torch and and some... percussive persuasion to get the correct angle but wasn't too bad. The only issue I've had is...
  5. Water Cooled Twins Technical Talk
    Hi! I assume I am supposed to be looking for a short in the wiring. - Indicators work fine, then I use hazard switch and indicators stop working altogether for about 20 seconds. My bike has aftermarket LED's that were poorly installed, I found one indicator had ground & power in wrong plugs...
  6. Hinckley Classic Triples
    Fairly easy project if you can keep track of the various fittings, screws and rings to keep the headlight unit secure. Plug and play. Way brighter that the stock unit.
  7. Water Cooled Twins Technical Talk
    I am thinking about replacing turn and brake signals on my Thruxton 1200 R with LEDs. Mostly to get brighter lights, but also to lessen power consumption. I have some electric accessories hooked up (video camera recorder, phone/GPS charger) which are straining already weak battery. If there is...
  8. Maintenance & Workshop Talk
    Hello! I recently installed one of those cheap eBay led lights on my 14’ Bonneville. The light is working fine but I can’t get the halo ring to turn on at all The light has a H4 connector and there is another connector that v’s from that same line, which I assume is the connector that lights up...
  9. Club Cafe'
    Hello! I recently installed one of those cheap eBay led lights on my 14’ Bonneville. The light is working fine but I can’t get the halo ring to turn on at all The light has a H4 connector and there is another connector that v’s from that same line, which I assume is the connector that lights up...
  10. Air Cooled Twins Talk
    hey! would a 2018 LED headlight fit on a '15 Thruxton? what do you think?
  11. The Welcome Center
    Hi just bought a tail tidy from new rage cycles for my newly purchased 2015 Thruxton . Now have hyper flash a common problem ,I know . Whats the best fix ? Where's best to purchase from ? and finally is it easy to do :laugh2:? I'm in the UK
  12. Thunderbird Cruiser Chat
    All, Good evening from Ohio! So I bought a Sunpie LED (i.e. Amazon) to replace the original headlight. I've seen posts here and on the other site where TBird owners installed this unit and are happy with it. It only has the 3 'spade' connector and has no where to plug the two 'position light'...
  13. Club Cafe'
    I'm looking to install the Motogadget M.Blaze LED Pin signals on my 2015 Thruxton. I can't decide whether to get the shock mounts, or underseat mounts from Motone. Aside from personal preference, is there anything functionally speaking I should be aware of when deciding on a mounting position...
  14. Led lights fitted

    Led lights fitted

    quick picture of 9w 12v PMMA Lens LED lights fitted to Trophy 1200
Top