Triumphrat

taximan62

Will this angled screwdriver work to adjust the carb sync screws?

http://www.motionpro.com/motorcycle/...djusting_tool/

propforward

Yes it will - but there is quite a bit of room under there - many people just use a miniature right angle drive with flat bladed bit.

I always pull the tank when I balance the carbs - I like to have a clean around and check all the cables while I'm there. Pulling the tank only takes a couple of moments. Just my way of doing things.

__________________
Rule 1: Cardio

Rustic Road Progress

Olderslower

+ 1 Propforward. A simple offset screwdriver works fine. I like to keep tank on though and have a good fan blowing on the engine if I am going to have the engine running a bit. Gloves help to keep fingers from getting burned...

__________________
2008 T100 B/W, centerstand, Flanders narrow cafe bars, Manic Salamander barend weights, Sargent Seat, Works Performance Shocks, RaceTech Fork Springs and Emulators, A I removed, desnorkled, Dominator Touring exhaust, 118 mains, no shim, 2 3/4 turns

Baltobonneville

A mini-ratchet with a 2-inch Phillips bit also works fine and is cheaper. That Motion-Pro tool is overkill for this job.

__________________
Marty
2005 Bonneville Blue 790cc, AI removed, Staintunes RC, Unifilter, no snorkel, 118/40/Thrux needle/1 shim/3 turns, tachometer, Ikon 7610s in back, Ricor Intiminators in front, Pirelli Sport Demons, D9 gauge panel.

Kramocker

Try this:
http://www.homedepot.com/webapp/wcs/...ctId=100097038

At a buck 99 you can buy two!!!!!


Cheers,

SK

__________________
2007 T100 T&O - AI's off, ARK, K&N's, 42 pilots, 140 mains, 2 turns out, D&D silencers, ACR Adjustable Clubman's, KYB's, WP springs, Thrux gel seat______________________________________________
Who's that little old man with Paul?