Triumphrat

Broms

I would like to modify my side covers to be able to show the sweet looking cone filters of the NARK kit. I have seen some pics, but I don't seem to be able to find them now.

Any information would be greatly appreciated, please post pics of your covers

REVOLT

I marked out the cut line...grabbed a coping saw with a fine cutting blade...then some 150grit to round the edges nicely...and some Flat Black paint...The most time consuming part was sanding down through the BONNEVILLE decal...




Anyhow...I think the modified covers accent the kit well...Good Luck!

PS...they are a bit different...each side, so don't make a template for both...

__________________
The Bonnie Situation...

Broms

Thank you for the pics Revolt...just the result I am hoping for !

Brooksie

Clean job Revolt. Looks great!

REVOLT

Thanks Gents!!

__________________
The Bonnie Situation...

Kframe

I like the bottle-cap choke knob, nice touch!
-K

jcline8

These covers look great!

__________________
2005 Bonnie Black

mecscc

Revolt: coming from a guy who doesn't modify anything, I'll tell you that is really good looking! Great job.

__________________
Monte

"The Old Ohio Preacher Man"

BellaCorse

That choke knob is priceless. I'll pick-up a 12 pack tomorrow.

/Mike

RedBird

Ditto on the choke knob.

__________________
Larry
2003 T-100 (790cc), NARK, NH Togas, 8100 rpm rev limiter, 158 main jets, 42 pilot jets (less than 1 turn out on pilot screws), stock needles--no shims. 13 A/F ratio from 1100 rpm to 4000 rpm; 12 A/F ratio from 4000 rpm to 6000 rpm; 13 A/F from 6000 rpm to 8100 rpm.:D
2007 Tiger 1050--White:D--SW-Motech crashbars, Skidmarx rear hugger/chain guard, Calsci +7 windscreen.