Triumphrat

HIM

Just installed new flashers from BC (small 2 wire) I did hot have any connectors, so used electrical tape. Now when I indicate all 4 flashers run in emergency flash mode. This seemed pretty straight forward. Famous last words!
Thanks for any help.

__________________
Fat people are harder to kidnap

Bugsy-12GSRC

You will more than likely need a load equilizer, same as used on harleys etc. that have led lights, they are easy to install having only three wires. I had to install one on mine when i put on led indicators.

[ This message was edited by: Bugsy-12GSRC on 2007-06-19 08:24 ]

HIM

Well, after blowing a couple of fuses, l looked up similar problems on the board and found that Sweatmachine had similar problems.
I ended up trying all connections the opposite of what you would think. (or what I would have thought)
Black to white (fronts both)
Black to orange(rear)
Black to brown(rear)
White to black (rear)
White to black (rear)

__________________
Fat people are harder to kidnap

mecscc

Sorry, wrong thread. I thot you had something else in mind.

Monte :-D :-D

__________________
Monte

"The Old Ohio Preacher Man"