Triumphrat

Tenover · 04-16-2006, 12:23 PM

I just received the MotoTwin headlight grille, and I'm sure it's the easiest thing in the world to install, but I can NOT figure out how these dang clips are supposed to fit. The instructions say to bend them for tension, which I did, but even then, the grille doesn't seem to want to hoild properly. Any tips? Thanks.

Sheepdog · 04-16-2006, 02:53 PM

In the Club Cafe section, there was quite a bit of conversation about this. Apparently, the clips are universally considered a poor design. The few folks that can make them work report that if a rock did strike, the entire screen would just fall off. One enterprising fellow used velcro to attach his and reports success. You may wish to search for these threads in Club Cafe...

rideabout · 04-16-2006, 04:03 PM

I safety wired mine on in 3 places instead of using the clips.