Triumphrat

tyrebyter

Has anyone modified the top triple clamp to accept "Fat Bars" with 1 1/8" tubing at the clamps? Wondering if there is enough meat to bore the existing clamps.

blacktiger

You could try here :- http://www.roxspeedfx.com/cgi-bin/cart/showitems.cgi?subcat_id=269[addsig]

__________________
H
'02 Tiger955i in black.

tyrebyter

Not sure what was in your cart but I didn't have the associated cookie. Was it clamps?

blacktiger

http://www.roxspeedfx.com/cgi-bin/ca...?subcat_id=269
or
Just try :- http://www.roxspeedfx.com

Basically, they have risers that clamp into the original clamps and have another clamp above. Difficult to explain but they look like they'll work for you..

[ This message was edited by: blacktiger on 2006-08-17 11:08 ]

__________________
H
'02 Tiger955i in black.

tyrebyter

Yes. That would do it. May try to do something a bit less busy if there is enough room. The original post/clamp is quite tall so I was thinking about milling it down some and boring new saddles closer to the top of the triple clamp. Although, I have visions of really screwing this up and seaching ebay for a new triple clamp.