Triumphrat

Wolf · 06-01-2012, 05:22 AM

We've just finished out prototyping and testing for our slip on for the Explorer but before it can go in to production we need to check fit it on a second bike (we did all our R&D on one and to make sure there aren't slight differences bike to bike we need to check on another)

So if anyone in the UK would be willing to help, we would like to send you a pipe to test it fits and then we'll collect it again and put them in to production.

Of course for the favour of helping out if you decide you'd like to buy one when they are in production we'll do one at trade to you

PM me if you can help - fitting of these is very easy and should only take 5 minutes of your time...

Thanks

okcrich · 06-03-2012, 11:28 PM

I'm not in the UK, but I'll give it a go. Have you thought about testing it at high altitude? I rode up to Pikes Peak today (14,000 feet, 4,000 meters above sea level! I can send you a picture of my bike with your pipe at any number of scenic spots in Colorado.