Centerstand hardware

[Dittos3]

Ok - I have a '95 Speed Triple and a '95 Speed Triple centerstand, complete with springs.

What I do not have are the nuts and bolts to make all the above mentioned items 1. Any suggestions?

[KitNYC]

According to the fiche over at BB, the hardware consists of (2) Torx screws, countersunk, M10x65mm, (2) locknuts, M10x1.5 (I assume this "x1.5" refers to thread pitch), and 2 centerstand sleeves. If you have the sleeves, you can get the nuts & bolts for about $10 shipped from Bolt Depot or McMaster, else it looks like $20 at the dealer.

Cheers,
-Kit

[Dittos3]

Thanks Kit. I do not have the sleeves.

Where on the BB fiche did you find the centerstand? I could not locate it.

I figured it would be you replying...

[KitNYC]

I have a 3rd interview for a job on Thursday. What are y'all gonna do if I get hired?

*Besides* the collective sigh of relief!

Seriously, I looked at the sidestand fiche for a Trident. It's usually under "Sidestand and Centerstand" on BB, and I figured it would only be shown on a model that shipped with it.

Cheers,
-Kit

[Dittos3]

I'd much rather you get the job than cater to me. Abusing you 24/7 for free just don't feel right!

Thanks for the info, and Good Luck Thursday!

[KitNYC]

Thanks, man. Here's hopin'!

[KiwiGeoff]

Hey Kit - Does your prospective employer know that you are one of the world's leading authorities on Triumph S3s and that you run a 24/7 Agony aunt column for the cast of thousands using this site?

Should be worth something in my book.

Good luck - KiwiGeoff

[KitNYC]

Thanks, Geoff. It's not on my resume yet, but Apple does have a job posting here for a Forum Moderator...

Cheers,
-Kit

[Scarletfever]

Nuts, bolts, sleeves and springs cost me £14 odd last year from the dealer. Figured i might as well get new springs while I was at it. Seems like parts prices are a bit steeper over there.

Good luck with the job Kit!