Special Tools for 2005-7 S3

[leeshelford]

Wakey,wakey I'm posting this thread, as I want to get up a comprehensive S3 kit of
factory Special tools for the motor ,forks etc etc . I'm South coast NSW & looking for like minded individuals so we can pull together to buy a set of factory special tools or better still borrow them from a dealer !!! then see if we can get accurate copies made by a toolmaker at a much cheaper rate ,as to buy a set for youself will cost upwoods of $1000.00 at least(not practical ) but between a few likeminded people maybe we can make it happen.
Any one else intrested in this or ,have sensible input on the subject please I'd like to hear what you have to say.
Stay upright boyz & girls . Lee

[onicrom]

fork seal driver: sheet of aluminum rolled to the appropriate diametre, wrapped in duct tape, and a little cloth at the end to buffer the blow

or: with inverted forks you can use the slider tube itself to drive the seals in, just use the 2 old seals as a buffer as to not damage the new one.

Wheel removal tool: 24mm bolt with 2 nuts (i think thats the right size)

[dblhelx]

22mm for frint wheel.