Pro Taper Bars 1" Anybody try them??? Clamps??

what kind of risers (mounts) did you use?

[zooplancton]

i have them o n my cr500.
totally indestructible.

here's a place

and



note: these risers are also offset, so they are closer to you. i think it would be a good combo.

edit: that specific page is for my 7/8's, but they also have 1" clamps if i remember right.another place

[ This message was edited by: zooplancton on 2006-12-28 20:38 ]

[zooplancton]

here ya go.

over sized clamps

[roadkill]

i have pro tapers and have used on the speed triple, but removed them because i could not fit my napolean bar end mirrors with them.

They looked cool. I used adapters I got from bajadesigns.com to install in place.

Any dirt bike shop should have it. This was the same setup I had on my xr650r.

[Mesoam]

the universal risers will need some custom work

you will need to trim them down in height and width

you will need to bore the bolt hole for the factory risers out a bit and either use washers to space the factory recess flush or ger a custom spacer

also new bolts or again washers will be needed on the underside of the top clamp