alright , if figured it out , i will take some pictures with the flash
tomorrow ,
i managed to retain the plate illuminator as well as the stock turn signals
the are partialy hidden by the plat and the angle upward towards the
gap between the pipes and the tail
One suggestion, be careful of the suspension bottoming out. I made an alteration when I first bought mine. I stopped on a long hard ride to take pics, and the license plate was bent upwards. I couldn't figure it out, then it clicked. The plate was set too far back. Just a suggestion.
it has about six inches of travel and i bent the bottom of plate up a little so it would not dig in , i might giv it a diferent angle when i make my
bracket at work , this one is just a cobble together to get fit and such.
i retained my plate light it is why the plate is glowing in the last picture , i drilled two small holes and mounted under the brake light facing forward
there is a small triangular hole there that i covered with the light housing
i will post some better pictures tonight when iget in from work
i like the high mount double cans , and i plan to integrate the
blinkers a little better in the next piece i make as well as moove it farther forward , i have not made up my mind about the integrated tail light yet though
Linear Mode
