|
Last night I was working in the garage and I switched on the S3 to see what the odo read. I accedentally left it on when I took my 400F out for a bit of a ride. When I came back, my battery (brand new Yuasa) was completely drained. I jumped the bike with one of htose portable battery packs, rode it for a while, and its bahaving just fine. However, since I drained the battery and jumped the bike, the 'Engine' LED has been illuminated. I know there isn't a lot to the FI system in this bike (compared to a car), but I'm not sure what could have caused this. All instruments are working and the bike starts and runs normally.
Additional info: The bike has an aftermarket pipe and a power commander. I also accidentally ran at least a gallon of leaded through it (poured from the wrong can in the garage) about 500 miles ago. I realize this is bad for the O2 sensor, but it was some time ago and this seems more than coincidental.
Is there a way to reset the light and see if it comes back?
- Matt
|
Linear Mode
