Triumphrat

SoCal · 05-03-2004

Bike is a 1998 Trophy 1200

Looks like I need to replace my "Clutch Pushrod Seal" as I am getting a few drops of oil leaking out of the clutch slave cylinder housing drain hole when I ride. I checked my Triumph service manual but didn't find where this is described... I am assuming you just pop / pry the old seal out and pop the new one in-

Does anyone here have experience replacing this seal?

EdC · 05-03-2004

Yep Socal. I just pried the old one out with a small screwdriver and popped the new one in. It's a tight fit. The Haynes manual says to push it in with thumb pressure but I couldn't get mine all the way in with just my thumb. I used the back of a hammer handle to push it in fully.

BTW..... be sure that it's engine oil that is leaking and not hydrolic fluid from the clutch.