1) Is this my pre cat?: see photo attached. Can I just rrip it out with some tools or is there much more to the story here? (like who put cardboard in my pipe?)
2) DO you have to remove the oil cooler to get the headers of? If not, what am I missing? Everything is unbolted but it seems like the top of the header is too wide to slide under the filter and I dont seem to see a way to pull the header out through the front...
:???: :???:
image wont post:
http://new.photos.yahoo.com/cwb4tx@s...804406471723/0
pipe photo (click here)
[ This message was edited by: cwb4tx on 2007-05-30 21:41 ]
Linear Mode
