Parts swap list

keystonejenks · #1 (**permalink**) 09-06-2005

I saw the one in the General Forum but it didn't do me much good. Then, I saw the one in the 600 forum. Well, why the hell don't we have one!!!!

I sure would like to know what front signals swap out with the 955. Who knows what parts will fit where? List them:

Hinckley · #2 (**permalink**) 09-06-2005

OK..... This is officially it...

Tell us what you know!!!

Hinckley · #3 (**permalink**) 09-06-2005

Tokico calipers from mid nineties GSXR, GSX1300, ZX7R, ZRX will bolt up to the T3 forks for a 6 pot upgrade....

HardCharger · #4 (**permalink**) 09-06-2005

whould that upgrade work on t595? and whats the cure for the crappy back brake?

Hinckley · #5 (**permalink**) 09-07-2005

Quote:

On 2005-09-06 15:19, HardCharger wrote:
whould that upgrade work on t595? and whats the cure for the crappy back brake?

Nope, you would have to make a bracket. The bolt spacing on the Tokico in question is 90mm.

As for the rear brake.... I have not had any problems with my rear brake.

bajajoaquin · #6 (**permalink**) 09-10-2005

Does anyone know if there are any rotor upgrades available? Or even a rotor swap for greater availability?

Hinckley · #7 (**permalink**) 09-10-2005

Quote:

On 2005-09-10 10:07, bajajoaquin wrote:
Does anyone know if there are any rotor upgrades available? Or even a rotor swap for greater availability?

For an upgrade, Galfer makes a set of wave rotors.

I just put a set on my Super III earlier this season.

Dave94Super3 · #8 (**permalink**) 10-07-2005

Fuel Tap kit for T300's is the same as for GSXR's... Sprint Manufacturing (UK) sell these...

Dave

SpitfireTriple · #9 (**permalink**) 10-07-2005

Dave (or anyone else for that matter!)

I've had a few problems related to my D900 fuel tap - specificallly, the vaccuum-operated switch stopped working, starving the engine of fuel. I've had to run it on Prime. Is this the sort of thing the Sprint Mfg item would cure do you know?
Or is my problem down to a kinked vaccuum pipe as I've read on another thread?

To make this post more like a "parts swap" item, I had no problem fitting a centre-stand off a Trophy(?) Sprint(?) to my D900.

[ This message was edited by: SpitfireTriple on 2005-10-07 10:33 ]

terrymc · #10 (**permalink**) 10-08-2005

hi spitfire,
sounds an aweful lot like the pinched vacuum hose to me I have had this happen a couple of times on my speed triple, but it usually happens when removing the tank and reinstalling, at least in my case.