Triumphrat

argie

Have a 69 T100, took out the trans (clutch plates,etc) and removed the inner gear box assembly. When I put the inner assembly back in ,the gear selector cam plate won't move, feels like its binded. Any suggestions would be appreciated, I haven't put the trans side back in yet

NHOJ from Maine

i too have a 69 T100...
i bet some more knowledgeable then i can answer this, but my 2 cents..

been years since i had my gear cluster out, but i seem to recall the forks had to be in a certain orientation on re-installation of cluster.. double check your manual is about the best advice i can give..
i also seem to recall a spring loaded 'thingy' on the primary drive side that was a bit tricky, and had to be tended to before gear cluster went back in..

if someone hasn't answered your prob. today, i will take a peek at my manual tonight to see if i can help ye...

good luck..
ps... the most 'fun' you will have is installing your kickstarter spring.
make sure your washer is in good condition. it is like defusing a landmine.. -j