Triumphrat

ironduke

I've been looking for an experienced person to resleeve 3 Amal 600 Concentric carburetors on the US side of the pond. Seems like a wide range of materials used to resleeve (brass,chrome plated brass, steel). Any opinions or sources?

GrandPaulZ

www.tritonmachining.com

__________________
GrandPaulZ
Author of "Old Bikes"
Born Again Bikes
My Photo album

TBAbob

I'm also looking for a reliable rebuilder for the AMALs on my BSA Rocket 3 resto project.

Cogito ergo equito

Bob

Cuppa500

Over time I've had two carbs re-sleeved. One was done in brass & the other in stainless steel. Both were equally good.
Cuppa

TRI-AL

Would it not be cheaper and wiser in the long run to simply by NEW? I did with no regrets & no needless screwing around. :hammer:

__________________
...and the Rocket's red glare


The jig is up.
The news is out.
They finally found me!
Styx... (Renegade)

Ride each ride like it may be your Last!