Triumph Rat Motorcycle Forums banner

04 Tank Badge inner logo moves a little

770 views 4 replies 3 participants last post by  RJ64 
#1 ·
Hey guys , so on my tank badge, the inner "triumph" logo moves up and down on one side. I haven't taken it apart but I'm assuming after I take the whole badge out with the torx safety screws, the logo is rivited? How would I get it to stay in place . Also does anybody know the triumph part number for my style ?



Sent from my iPhone using Tapatalk
 
See less See more
1
#2 ·
Just take the badge off, and on the underside you'll see a crimping washer holding the triumph logo on. It's probably rusted and messy, but often times you can push it back down or twist it and get it to hold better. If it's toast, then you can either order the triumph parts and wait for them to ship... Or I found some equivalent parts at my local Ace Hardware store -- just take the logo in with you and find a washer to fit the stud on the back of the logo. They were about $.20 each IIRC.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top