|
Hi
When I fitted mine I placed the "T" into the plastic convaluted hoses from the throttle bodies. This is where it said in the instructions to install. Yes you need to remove the tank and the airbox but its quite straitforward.
In terms of location mine is mounted behind the frame behind the left side panel. The feed hose then runs under the swinging arm and I modified the bracket and pop riveted it in an existing hole in the swing arm. Drain hole I think.
The resevior is secured with a large tie wrap using the mounting rubber filler to hold the unit upright, with the tie wrap going around the frame. The resevoir can be seen from above and adjusted. I also cut the fill tube so that it tucks away under the seat and yet can be pulled out for filling. The resevoir is a tight fit beside the shock unit but I wanted it tucked away.
It works a treat, cannot be seen, but a bit fiddly to fill.
Good luck
|
