|
Bob that fender!
Cut the rear fender along the mold seam. File and clean up the cut. Now take your original license plate holder and flip it up-side down and remount it to the rear portion left showing which will be the rear most point of the under tray area where Triumph packs the tail light wires and turn signal wires. (I trimmed mine a bit, but it's not really necessary.) I suggest you lay out the height with the plate installed and any frame you may wish to use to check for interference. I used an aluminum black minimum frame and it tucks up very close indeed. Re-drill the sides of the same storage area (which is visible below the bodywork) for your turn signals. (reuse stock or get some smaller ones if you prefer) Price.....$0.00 to $25.00 depending on how much you spend on frame and or new turn signals!
Hint: If you want to use aftermarket turn signals the Stock Triumph connectors used on the turn signals is a standard .093" Molex connector available at any good electronics store. The connections are available at Radio Shack as well, but they do not carry the single Molex Male and Female body's.
|
