The shims are as simple as M10 washers which were pretty much ~ 1.5mm thick - just use 6 (or 5 in your case) between the rotor & the wheel hub on each side - that should do the trick.
I may ultimately get some full circle spacers made up for when I eventually get my waves but this is working fine for now.
This is how it ends up - note in second pic that it appears like a bigger spacer than actually is, the rotor already has an offset away from the wheel hub which makes it look more.
p.s. My forks aren't really that ratty - just dust on there that the flash decorates incredibly!
[ This message was edited by: DEcosse on 2006-11-12 10:59 ]
