Quote:
On 2006-06-25 18:00, SCCTrim wrote:
Thank's for the link to Bill. I'm not intrested in machining the case's so the wiseco kit will be what I am after. I'll be sure to let Bill know about the cylinder from you. Assuming I would want to keep the compression down from the 10.1 the wiseco kit advertise's...would I want a cylinder more than +3mm?
Off to stretch the leg's a bit :-D
Thank you sir :upthumb:
SC
|
Yes, good call. You want 3.7mm to keep the CR. With 3mm it would go to 10.8, should work if you use high octane gas
