|
Jeffers,
From the manual, pg 10-4.
DRAINAGE
6. Remove the coolant drain plug and disconnect the bottom hose at the water pump.
FILLING
1. Refit the coolant drain plug (where DMc said it was) and tighten to 13Nm.
2. Reconnect the bottom hose at the water pump and secure with hose clip.
3. SLOWLY add coolant mixture to the system, through the radiator opening, until the system is full.
4. Fit a new washer to the radiator bleed screw. Refit the screw and tighten to 12Nm.
5. Refit the coolant pressure cap.
6. Reconnect the battery positive (red) lead first.
7. Start the motorcycle and allow the engine to idle for a short period of time to allow any air to be expelled from the system.
8.stop the engine and top off the coolant level as necessary.
HTH, Steve
|
