Quote:
Originally Posted by polex
I mounted the nology coils but the cylinder 3 doesn't works yet.
I disconnected cylinder 3 spark-plug and the idle is the same.
|
Look very carefully at the connectors on the ignition coil.
The low voltage terminals can become corroded and are easily bent out of good contact.
Also, the rubber boots on the high voltage connectors will sometimes slide too far on the wire when removing the plug wires. This will cause the connector to separate and arc inside the rubber boot.
Make sure you pull the boot back a bit before you connect the plug wires so that there's a good connection before you slide the boot on.
Jim
